Avdel TX2000 Bedienerhandbuch

Threaded Insert Power Tool74201Instruction ManualOriginal Instruction

10Servicing the ToolIMPORTANTThe employer is responsible for ensuring that tool maintenance instructions are given to the appropriate personnel.The op

11Service KitServicing the ToolFor all servicing we recommend the use of the Service Kit (part number 74200-99990) supplied in its own plastic case.07

12MaintenanceEvery 500,000 cycles the tool should be completely dismantled and components replaced where worn, damaged or whenrecommended. All ‘O’ rin

13Differential ValveHead AssemblyRear CasingDistributorHydraulic Piston and Air Motor Assembly (74200-12610)Maintenance• Wrap adhesive tape around Hyd

14General Assembly of Base Tool 74201-120002610710810010110910211010310411110511211310624116 Assy11415171830515914038423924411993644434546474835363132

15Parts List for 74201-120000102030405060708091011121314151617181920212223242526272829303132333435363738394074200-1209174200-1209274200-1204407003-000

16Pressure Switch AssemblyGeneral Assembly of Base Tool 74201-1200081828580838752845389909391949286• Remove Casing Cover 92.• Using spanner remove Rea

Oil DetailsHyspin®VG 32 Oil Safety DataPriming ProcedurePrimingPriming is ALWAYS necessary after the tool has been dismantled and prior to operating.

18Fault DiagnosisPneumatic motor Air leak from motor Check for worn seals. Replace 13runs slowly Low air pressure Increase 7Air way blockage Clear res

19Fault DiagnosisTool does not Screw adaptor nut loose Tightenspin on No air supply Connect 7Insufficient gap between Lock Nut 6 and Adjust gap to be

20Notes

21Notes

22Notes

This box contains a power tool which is inconformity with Machines Directive2006/42/EC. The ‘Declaration of Conformity’is contained within.Declaration

Since 1 936 2010 Since 1922www.avdel-global.comwww.infastech.com02.2011 • © 2010 InfastechAutosert® (equipment), Avbolt®, Avdel®, Avdelmate®, Avdel TX

3ContentsLIMITED WARRANTYAvdel makes the limited warranty that its products will be free of defects in workmanship and materialswhich occur under norm

4Safety Rules1 Do not use outside the design intent.2 Do not use equipment with this tool/machine other than that recommended and supplied by Avdel UK

Tool SpecificationTool DimensionsSpecifications5Air Pressure Minimum - Maximum 5-7 bar (75-100 lbf/in2)Free Air Volume Required @ 5 bar/75 lbf/in27.5

6Intent of UseThe 74201 hydro-pneumatic tool is designed for placing Avdel®threaded inserts and is ideal for batch or flow-line assembly in a widevarie

• Connect the tool to the air supply. Adjust the pull force.• Offer up insert, lip first, to the drive screw. A slight pressure on the trigger will sta

8Fitting InstructionsServicing InstructionsNose AssembliesIt is essential that the correct nose assembly is fitted prior to operating the tool. If you

9Nose AssembliesNose tips vary in shape according to the insert type. Each nose assembly represents a unique assembly of components which can beordere