Avdel TX2000 Bedienerhandbuch PDF herunterladen (Seite 7)

• Connect the tool to the air supply. Adjust the pull force.

• Offer up insert, lip ﬁrst, to the drive screw. A slight pressure on the trigger will start the motor and automatically thread the insert

up against the nose tip and stop.

• Insert fastener squarely into application.

• Fully depress the trigger. This will both place the insert into the application and disengage it from the drive screw.

Do not connect the tool to the air supply until all the components are in place, as indicated in the drawing on page 14.

Item numbers in bold refer to the General Assembly drawing and Parts List (pages 14-15).

Air Supply

Force Adjustment

Operating Procedure

Putting into Service

All tools are operated with compressed air at an optimum pressure of 5.5 bar. We recommend the use of pressure regulators and

automatic cooling/ﬁltering systems on the main air supply. These should be mounted within 3 metres of the tool (see diagram below) to

ensure maximum tool life with minimum tool maintenance.

The ﬂexible hoses should have a minimum effective working pressure rating of 150% of the maximum pressure produced in the system

or 10 bar, whichever is the highest. Air hoses should be oil resistant, have an abrasion resistant exterior and should be armoured

where operating conditions may result in hoses being damaged. All air hoses MUST have a minimum bore diameter of 6.4 millimetres

/4 inch.

Read servicing daily details page 10.

TAKE OFF POINT

FROM MAIN SUPPLY

STOP COCK

(USED DURING MAINTENANCE

OF FILTER/REGULATOR

OR LUBRICATION UNITS)

MAIN SUPPLY

DRAIN POINT

PRESSURE REGULATOR

AND FILTER

(DRAIN DAILY)

AIR LUBRICATION

PERMISSABLE

Allen

Key

After ﬁtting the appropriate nose assembly for the insert to be placed,

connect the tool to the air supply hose.

Using the 3mm allen key, unscrew the Regulator 93* a few turns until

pressing the Trigger 40 produces no pull on the spindle.

To conﬁrm this, screw an insert onto the spindle and press the trigger. The

insert will not deform and the tool will begin to spin off.

To adjust the pull force, screw in the Regulator 93*approximately half a turn

and repeat the operation with the same insert (for each trial operation, screw

in the Regulator 93* until deformation of the insert takes place without any

change in thickness). When this stage is reached, this will be the minimum

force required to deform the insert .

After a successful trial insert deformation, check the thickness and increase

the force if the insert is not sufficiently formed.

Usually, this last adjustment requires a slight increase in the tightening of

Regulator 93*.

The tool is now ready to operate.

When dealing with different thicknesses, set it for the greatest thickness.

93* See page 16 Pressure Switch Assembly.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Avdel TX2000 Bedienerhandbuch Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrowerkzeuge Avdel TX2000