Avdel TX2000 Bedienerhandbuch PDF herunterladen (Seite 17)

Oil Details

Hyspin

VG 32 Oil Safety Data

Priming Procedure

Priming

Priming is ALWAYS necessary after the tool has been dismantled and prior to operating. It may also be necessary to restore the full

stroke after considerable use, when the stroke may have been reduced and fasteners are not now being fully placed by one operation

of the trigger.

The recommended oil for priming is Hyspin

VG32 available in 0.5l (part number 07992-00002) or one gallon containers (part number

07992-00006). Please see safety data below.

IMPORTANT

All operations should be carried out on a clean bench, with clean hands in a clean area.

Ensure that the oil is perfectly clean and free from air bubbles.

Care MUST be taken at all times, to ensure that no foreign matter enters the tool, or serious damage may result.

The tool must remain on its side throughout the priming sequence

• Place tool on its side, Oil Plug 35 side up.

• With an Allen key, unscrew Oil Plug 35 and remove with Oil Seal Washer 36.

• Fill tool with priming oil rocking gently to expel air.

• Replace Oil Seal Washer 36 and Oil Plug 35 and tighten.

• You must now bleed the tool. This operation is to ensure air bubbles are eliminated from the oil circuit.

• Ensuring oil Bleed Screw 10 is fully tightened unscrew by ONE TURN only, using an Allen key. Connect the tool to the air supply

and depress the Trigger 40.

• Wait until oil appears all around Oil Bleed Screw 10 then re-tighten. Wipe excess oil away.

• Release the Trigger 40.

• Using an Allen key remove Oil Plug 35 and Oil Seal Washer 36.

• Top-up with priming oil to reset level. Replace Oil Seal Washer 36 and Oil Plug 35 and fully tighten.

• It is necessary to ﬁt the appropriate nose equipment and adjust the tool stroke prior to operating the tool.

Item numbers in bold refer to General Assembly drawings and Parts List (pages 14-15).

First Aid

SKIN:

Wash thoroughly with soap and water as soon as possible. Casual contact requires no immediate attention. Short term contact

requires no immediate attention.

INGESTION:

Seek medical attention immediately. DO NOT induce vomiting.

EYES:

Irrigate immediately with water for several minutes. Although NOT a primary irritant, minor irritation may occur following contact.

Fire

Flash point 232°C. Not classiﬁed as ﬂammable.

Suitable extinguishing media: CO

, dry powder, foam or water fog. DO NOT use water jets.

Environment

WASTE DISPOSAL: Through authorised contractor to a licensed site. May be incinerated. Used product may be sent for reclamation.

SPILLAGE: Prevent entry into drains, sewers and water courses. Soak up with absorbent material.

Handling

Wear eye protection, impervious gloves (e.g. of PVC) and a plastic apron. Use in well ventilated area.

Storage

No special precautions.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Avdel TX2000 Bedienerhandbuch Seite 17

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrowerkzeuge Avdel TX2000